Necessary preliminary tasks

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2011 BMW 328xi, 2011 BMW 328i, 2011 BMW 323i, 2010 BMW 328xi, and 2010 BMW 328i. However, it is still accessible from the selected car via links, so may be relevant.

After completing this operation, check FLUID LEVEL IN TANK OF POWER STEERING SYSTEM .
Remove RADIATOR

Press lines (1) in direction of cooling loop, pull black locking ring towards rear. Keep locking ring pressed and detach lines (1) from cooling loop.

IMPORTANT: Catch and dispose of emerging oil.

Press lock (2). Pull cooling loop (3) of power steering towards rear out of holder.

Fig 1: Pulling Power Steering Cooling Loop Out Of Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock seal (1) in direction of arrow and remove.

Release screw.

Fig 2: Removing Seal

Courtesy of BMW OF NORTH AMERICA, INC.

Remove A/C condenser towards rear top from fixtures.

Carefully tilt condenser (1) in direction of engine, taking care not to damage the condenser or lines in the process.

NOTE: Lines of A/C system remain connected to condenser.

Fig 3: Pulling Power Steering Cooling Loop Out Of Module Carrier

Courtesy of BMW OF NORTH AMERICA, INC.

Pull cooling loop (2) of power steering out of module carrier and remove.