Necessary preliminary tasks

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2011 BMW 328xi, 2011 BMW 328i, 2011 BMW 323i, 2010 BMW 328xi, and 2010 BMW 328i. However, it is still accessible from the selected car via links, so may be relevant.

Remove coolant cooler
If necessary, slacken power steering cooling coil; refer to REMOVING AND INSTALLING/RENEWING COOLING LOOP FOR POWER STEERING .
If necessary, slacken A/C condenser and secure against damage and against falling down. Refer to REMOVE A/C CONDENSER .

Release damping pieces.

Fig 1: Locating Damping Pieces

Courtesy of BMW OF NORTH AMERICA, INC.

Press lock (1) and remove holder (2) downwards.

Illustration shows the left holder: The same procedure applies to the opposite side.

Installation:

Rubber mounts fall out easily, ensure correct installation position.

S65 only: Engine oil cooler loose, see Removing oil cooler.

Fig 2: Removing Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Remove module carrier (1) individually towards bottom.

Fig 3: Identifying Module Carrier

Courtesy of BMW OF NORTH AMERICA, INC.

When replacing module carrier:

Convert power steering See 1711370 REMOVING AND INSTALLING/RENEWING COOLING LOOP FOR POWER STEERING or 1711370 REMOVING AND INSTALLING/REPLACING COOLING COIL FOR POWER STEERING (N54, N52, N52K, N51, N53, S65) .