Replace aluminium screws
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2011 BMW 328xi, 2011 BMW 328i, 2011 BMW 323i, 2010 BMW 328xi, and 2010 BMW 328i. However, it is still accessible from the selected car via links, so may be relevant.
Tightening torque 12 52 2AZ .
CYLINDER HEAD COVER ILLUSTRATION CHART
| Work step | Note |
|---|---|
| Unlock plug connections on ignition coils and disconnect | |
| Unlock plug on eccentric shaft sensor and disconnect | |
| Unlock plug on positioning motor for eccentric shaft and disconnect | |
| Unlock plug on both solenoid valves and disconnect | |
| Unlock plug on inlet and exhaust camshaft sensors and disconnect | |
| Unlock plug on air-conditioning compressor and disconnect | |
| Unlock plug on oil pressure switch and disconnect | |
| Unlock plug on coolant temperature sensor and disconnect | |
| Disconnect connector strip from fuel rail | |
| Unlock plug on electric coolant pump and disconnect | |
| Unlock plug on coolant thermostat and disconnect | |
| Disconnect engine ground connection | Tightening torque 12 52 3AZ . Replace screw. |
NOTE:
Check stored fault messages.
Delete fault memory.
Delete fault memory.