11 31 505 Adjusting timing of camshaft(s) (N52K): Installation

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2011 BMW 328xi, 2011 BMW 328i, 2011 BMW 323i, 2010 BMW 328xi, and 2010 BMW 328i. However, it is still accessible from the selected car via links, so may be relevant.

Install fastener (1) with bore facing outwards.

Fig 1: Installing Fastener

Courtesy of BMW OF NORTH AMERICA, INC.

Rotate crankshaft at central bolt into TDC position.

Slide special tool 11 0 300 in direction of arrow into special tool bore and secure crankshaft.

IMPORTANT: On vehicles with optional extra SA205 (automatic transmission), there is a large bore for the TDC position shortly before the special tool bore. This bore can be confused with the special tool bore.

Fig 2: Sliding Special Tool 11 00 300 Into Special Tool Bore For Securing Crankshaft

Courtesy of BMW OF NORTH AMERICA, INC.

If the flywheel is secured in the correct special tool bore with special tool 11 0 300 , the engine can no longer be moved at the central bolt.

With 1st cylinder in firing TDC position, cams of inlet camshaft (1) at 1st cylinder point upwards at an angle.

Fig 3: Identifying Cams Of Inlet Camshaft

Courtesy of BMW OF NORTH AMERICA, INC.

Part numbers (2) on inlet and exhaust camshafts (1) point upwards.

Fig 4: Identifying Part Number On Camshafts

Courtesy of BMW OF NORTH AMERICA, INC.

With 1st cylinder in firing TDC position, cams of exhaust camshaft (3) at 6th cylinder point downwards at an angle.

Cam follower (1) is not actuated.

NOTE: When the engine is installed, the position of the exhaust camshaft (3) for the timing can only be checked with a mirror.

Fig 5: Identifying Camshaft Position With Cam Follower

Courtesy of BMW OF NORTH AMERICA, INC.

Secure special tool 11 4 283 to cylinder head with bolts (1).

NOTE: Fit special tool 11 4 282 underneath on side of inlet camshaft.

Mount special tool 11 4 281 on inlet and exhaust camshafts.

Fig 6: Identifying Special Tools Fitted To Camshaft And Cylinder Head

Courtesy of BMW OF NORTH AMERICA, INC.

Release central bolts (1).

Release central bolts (1) with special tool 11 4 280 only.

Release chain tensioner (2) (have a cleaning cloth ready).

NOTE: Picture in CAD and does not show special tools.

Fig 7: Identifying Central Bolt And Chain Tensioner

Courtesy of BMW OF NORTH AMERICA, INC.

Turn sensor gears (2) in direction of arrow until locating pins (1) on special tool 11 4 290 match up.

Slide on special tool 11 4 290 in direction of arrow.

Fig 8: Turn Sensor Gears

Courtesy of BMW OF NORTH AMERICA, INC.

Secure special tool 11 4 290 with bolts (1).

Screw special tool 11 9 340 into cylinder head.

Pretension timing chain with special tool 00 9 250 to 0.6 Nm.

Secure both central bolts of inlet and exhaust adjustment units with special tool 00 9 120 to inlet and exhaust camshafts.

Tightening torque 11 36 1AZ .

Fig 9: Identifying Bolts With Special Tools (11 4 280, 11 4 290, 11 9 340 And 00 9 250)

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine.