Necessary preliminary tasks

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2013 BMW 328xi, 2012 BMW 328xi, 2011 BMW 328xi, 2010 BMW 335xi, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Remove FRONT WHEEL

Slacken nut (1), grip with Allen key if necessary.

Tightening torque 31 12 6AZ .

Installation:

Replace self-locking nut.

Unfasten screws (2).

Remove guide joint with compression strut from opening in swivel bearing.

Tightening torque 31 12 7AZ .

Installation:

Recondition thread in swivel bearing.

Keep guide joint and opening in swivel bearing clean and free from oil and grease.

Replace microencapsulated screws.

Fig 1: Identifying Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Guide joint tightly seated in swivel bearing:

IMPORTANT: The guide joint must be replaced once it has been driven out with the special tool.

33 4 205 Unscrew nut and screw special tool onto guide joint.

33 4 200 Drive guide joint out of swivel bearing with special tool.

Fig 2: Removing Guide Joint Out Of Swivel Bearing Using Special Tool (33 4 200)

Courtesy of BMW OF NORTH AMERICA, INC.

If necessary, screw nut (1) onto guide joint by a few turns.

If necessary, replace lower section 31 2 242 with lower section 31 2 246

Press guide joint with special tool out of compression strut.

Unscrew nut (1) and remove guide joint.

Installation:

Keep journal on guide joint and bushing in compression strut clean and free from oil and grease.

Fig 3: Pressing Guide Joint Out Of Compression Strut Using Special Tool (31 2 240)

Courtesy of BMW OF NORTH AMERICA, INC.