2710050 Replacing output flange for front axle output (ATC 300)
WARNING: This page is about a different car, the 2011 BMW 328xi, 2010 BMW 335xi, 2010 BMW 328xi, 2009 BMW 335xi, and 2009 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Do not move vehicle with drive power once propeller shaft has been removed.
Replace output flange only in conjunction with a new radial shaft seal.
After completion of work, check TRANSMISSION FLUID LEVEL .
Use only the approved gear oil in the transfer case. See TRANSFER BOX - OPERATING FLUIDS .
Failure to comply with this requirement will result in serious damage to the transfer box!
Replace output flange only in conjunction with a new radial shaft seal.
After completion of work, check TRANSMISSION FLUID LEVEL .
Use only the approved gear oil in the transfer case. See TRANSFER BOX - OPERATING FLUIDS .
Failure to comply with this requirement will result in serious damage to the transfer box!
Operation is identical to REPLACING RADIAL SHAFT SEAL FOR FRONT AXLE OUTPUT .