2611090 Removing and installing/replacing front centering mount for propeller shaft: Notes

WARNING: This page is about a different car, the 2006 BMW 330xi and 2006 BMW 325xi. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

REMOVE PROPELLER SHAFT .

Completely fill centering hole (1) with viscous grease.

Drive special tool 11 1 310 with a plastic hammer into centering hole.

The centering mount (1) is forced out of the propeller shaft by the pressure on the grease filling.

If necessary, top up grease repeatedly.

NOTE: To drive out the mount, you can also fill the centering bore with water instead of grease.

Fig 1: Installing Special Tool (11 1 310) Using Plastic Hammer

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Remove grease/water from mount bore.

Drive in centering mount (1) with special tools 11 2 030 and 00 5 500 into propeller shaft (observe protrusion).

Grease centering mount.

Grease: BMW Service OPERATING FLUIDS .

Fig 2: Installing Centering Mount Using Special Tools (11 2 030 And 00 5 500)
Courtesy of BMW OF NORTH AMERICA, INC.