Necessary preliminary tasks
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2013 BMW 328xi, 2012 BMW 328xi, 2011 BMW 328xi, 2010 BMW 335xi, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.
- Remove REAR WHEELS
- Remove fuel filler pipe
Release screws (1).
Tightening torque 33 55 1AZ .
Remove retaining bracket (2) and rubber mount (3).
Installation:
Keep retaining bracket (2), rubber mount (3) and anti-roll bar clean and free from oil and grease.
Clean rear anti-roll bar on both sides.
Position rubber mount on rear anti-roll bar.
Position retaining bracket on rubber mount.
Push rubber mount with retaining bracket on rear anti-roll bar to installation position.