Installing new rubber mount

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2013 BMW 328xi, 2012 BMW 328xi, 2011 BMW 328xi, 2010 BMW 335xi, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Insert rubber mount with spray-on points facing upwards in special tool 33 4 451, 33 4 452, 33 4 454, 33 4 453 and pull together.

Insert rubber mount in special tool 33 4 473.

Fig 1: Installing Rubber Mount In Special Tools

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Spray-on points of rubber mount must point to rear!

Align rubber mount by way of slot (1) at an angle to wheel carrier.

Fig 2: Identifying Rubber Mount Aligning Slot

Courtesy of BMW OF NORTH AMERICA, INC.

Pull rubber mount with special tool 33 4 465, 33 4 466, 33 4 475, 33 4 474 and 33 4 473 partially into the wheel carrier.

Remove special tool 33 4 450 and pull in rubber mount as far as it will go.

Fig 3: Pulling Rubber Mount Using Special Tools

Courtesy of BMW OF NORTH AMERICA, INC.