Removing and installing outer gaiter

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2013 BMW 328xi, 2012 BMW 328xi, 2011 BMW 328xi, 2010 BMW 335xi, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Release hose clamps (1, 3) and detach gaiter (2) from output shaft.

Clean joint and output shaft carefully.

NOTE: All traces off old grease must be removed.

Check joint for damage; if necessary, replace output shaft. See 3321001 REMOVING AND INSTALLING/REPLACING LEFT OUTPUT SHAFT or 3321002 REMOVING AND INSTALLING/REPLACING RIGHT OUTPUT SHAFT .

Fill joint with propeller shaft grease.

Fit gaiter (2) on bellows and secure with hose clamps (1, 3).

Fig 1: Identifying Hose Clamps And Gaiter On Output Shaft

Courtesy of BMW OF NORTH AMERICA, INC.