Installing front rubber mount

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2013 BMW 328xi, 2012 BMW 328xi, 2011 BMW 328xi, 2010 BMW 335xi, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Coat bearing bushing in rear axle carrier and front rubber mount with Circolight (referarts Service).

Front rubber mount must be aligned by way of slots (1) to vehicle transversal direction.

Fig 1: Identifying Front Rubber Mount Aligning Slots

Courtesy of BMW OF NORTH AMERICA, INC.

Insert front rubber mount in special tool 33 4 311.

Align front rubber mount so that side slots (1) line up with marking (M) on tool.

Fig 2: Aligning Front Rubber Mount Slots On Marking

Courtesy of BMW OF NORTH AMERICA, INC.

Draw in front rubber mount as far as it will go using special tools 33 4 465, 33 4 466, 3333 4 311 and 33 4 312.

Fig 3: Installing Front Rubber Mount Using Special Tools

Courtesy of BMW OF NORTH AMERICA, INC.