Installing rubber mount

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2013 BMW 328xi, 2012 BMW 328xi, 2011 BMW 328xi, 2010 BMW 335xi, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Coat bearing bush in rear axle support and new rubber mount with Circo Light (refer to Department).

Align rubber mount by way of elongated hole (1) to vehicle transversal direction.

Fig 1: Identifying Rubber Mount Aligning Hole

Courtesy of BMW OF NORTH AMERICA, INC.

Insert rubber mount (1) in special tool 33 4 283.

Align rubber mount (1) by way of elongated hole to vehicle transversal direction.

Draw in rubber mount (1) with special tools

33 4 282, 33 4 283, 33 4 284,

33 4 466 33 4 465 2 and as far as it will go.

Fig 2: Inserting Rubber Mount In Special Tool (33 4 283)

Courtesy of BMW OF NORTH AMERICA, INC.