Installing rubber mount

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2013 BMW 328xi, 2012 BMW 328xi, 2011 BMW 328xi, 2010 BMW 335xi, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Coat bearing bush in rear axle support and new rubber mount with Circo Light (refer to Department).

Draw in rubber mount with end shown from front into rear axle carrier. In so doing, make sure arrows on the rubber mount point upwards.

Fig 1: Identifying Rubber Mount Arrows Position

Courtesy of BMW OF NORTH AMERICA, INC.

Allign special tool 33 4 358 with rubber mount using openings.

Fig 2: Allign Special Tool (33 4 358) With Rubber Mount

Courtesy of BMW OF NORTH AMERICA, INC.

Pull on rubber mount (1) with special tools 33 4 357, 33 4 358, 33 4 466 and 33 4 4 as it will go.

Fig 3: Pulling Rubber Mount Using Special Tools

Courtesy of BMW OF NORTH AMERICA, INC.