Necessary preliminary tasks
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2013 BMW 328xi, 2012 BMW 328xi, 2011 BMW 328xi, 2010 BMW 335xi, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.
- Remove output shaft from rear differential. See 3321001 REMOVING AND INSTALLING/REPLACING LEFT OUTPUT SHAFT or 3321002 REMOVING AND INSTALLING/REPLACING RIGHT OUTPUT SHAFT and tie back
Using a suitable screwdriver and a hammer (acting as a rest), force drive flange (1) off rear differential.
Installation:
Replaced deformed or damaged dust plates.
Insert drive flange and rotate until spline on flange meshes with teeth on differential bevel gear.
Press drive flange in further until circlip locates with an audible click.
IMPORTANT:
High installation forces indicate that the spline teeth on the drive flange/differential bevel gear are damaged/deformed!
Check spline teeth, replaced damaged parts.
Check spline teeth, replaced damaged parts.
Install retaining ring (1).
Installation:
Clean shaft seal race on drive flange thoroughly.
Coat drive flange at contact face of shaft seal with approved rear differential oils. See REAR AXLE - OPERATING FLUIDS .