3121 Wheel Bearings and Steering Knuckle
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2013 BMW 328xi, 2012 BMW 328xi, 2011 BMW 328xi, 2010 BMW 335xi, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.
TIGHTENING TORQUE SPECIFICATION - WHEEL BEARINGS AND STEERING KNUCKLE
| Type | Thread | Tightening specification | Measure | ||
|---|---|---|---|---|---|
| 1AZ | Wheel bearing to swivel bearing | E81/E82/E87/E88/E90/E91/E92/E93 | M12 | Replace screws | 110 Nm |
| E84 | M12 | Replace screws | |||
| Jointing torque | 80 Nm | ||||
| Torque angle | 90 ° | ||||
| 2AZ | Drive flange to axle shaft | E90/Allrad, E91/Allrad, E92/Allrad | M27 | Replace collar nut, lightly oil contact surface No oil is permitted on the collar screw. |
420 Nm |
| E84 | M16 | Replace collar screw and spring. | |||
| Jointing torque | 210 Nm | ||||
| Torque angle | 90 ° | ||||