LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2010 >> Cooper S, 2D Hatchback, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2568 (Steering And Wheel Alignment - Repair - E90/E92 (AWD)) >> 3241 Pump And Oil Supply >> 3241060 Removing and installing or replacing hydraulic steering vane pump (N51, N52, N53) >> Screwing sequence

Screwing sequence

WARNING: This page is about a different car, the 2011 BMW 328xi, 2010 BMW 335xi, 2010 BMW 328xi, 2009 BMW 335xi, and 2009 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.
  1. Secure vane pump with screws
  2. Tighten side screws to 2 Nm
  3. Tighten front screws to 2 Nm
  4. Tighten down front screws to jointing torque and angle of rotation

    Tightening torque 32 41 6AZ.

  5. Release screws at side and check bolting points for gap freedom
  6. Tighten down side screws to jointing torque and angle of rotation

    Tightening torque 32 41 6AZ.

scientia non olet · About LEMON Manuals