63 12 860 Replacing control unit for left xenon headlight (from production date 07/13)

WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2015 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Version with xenon lighting system: Danger to life due to high voltage!

Disconnect all components from voltage supply before removal.

Work on the entire xenon lighting system (ignition device, control unit and bulb) may only be carried out by qualified personnel.

Comply with notes on handling HANDLING LIGHT BULBS (EXTERIOR LIGHTS) .

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Necessary preliminary tasks:

Remove LEFT HEADLIGHT

Release screws (1).

Tightening torque 63 12 5AZ .

Remove control unit for xenon headlight (2) from headlight (3).

Fig 1: Locating Screws Of Control Unit For Xenon Headlight

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

When installing the control unit for the xenon headlight (1), make sure the gasket (2) is correctly seated.

Fig 2: Locating Control Unit Screws For Xenon Headlight

Courtesy of BMW OF NORTH AMERICA, INC.