35 11 000 Removing and installing (replacing) complete bearing support for foot pedal: Notes

WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2015 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: After completion of work, carry out function check.

Necessary preliminary work:

Remove BRAKE SERVO

Release screws (1).

Remove control units from holder (2). Plugs remain connected.

Fig 1: Identifying Screws And Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Slacken nut (1).

Installation note:

Replace self-locking nut.

Tightening torque 35 11 2AZ .

Remove bearing support (2).

Fig 2: Identifying Slacken Nut And Bearing Support

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip line (1).

Disconnect plug connection (2).