LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2010 >> Cooper S, 2D Hatchback, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2560 (Collision - Body Panel Repair (F01, F02)) >> Support Members >> 41 11 095 Replacing Left Engine Support In Front Of Wheel Arch

41 11 095 Replacing Left Engine Support In Front Of Wheel Arch

WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2015 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.

Observe procedures for REPAIR STAGE 3 .

Read CONTENTS OF BODY, GENERAL .

Steel-aluminium composite construction is used on the vehicle.

Observe specific procedures for OPENING ADHESIVE BONDS , BONDING ALUMINIUM ON STEEL , and OPENING RIVETED JOINTS .

Use only approved spot-welding apparatus for repairs. See WORKSHOP EQUIPMENT .

Place vehicle on straightening bench.

Necessary preliminary work: 

Remove CARRIER SUPPORT 

The following new body parts are required:

Fig 1: Identifying Front Engine Support
G00491540Courtesy of BMW OF NORTH AMERICA, INC.

Mark severance cut in accordance with Dimension a and cut.

Dimension a=40 mm before wheel arch edge.

Remove section of engine support.

Installation note: 

Mark severance cut on new part in accordance with vehicle and cut.

Adjust new part to fit with alignment bracket or universal mount.

Weld in REINFORCEMENT PLATE  at severance cut.

Fig 2: Identifying Welding Area
G00491541Courtesy of BMW OF NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals