2.0 Surface Preparation

WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2015 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.

For better adhesion, remove oxide film and paint from the adhesive areas with a stainless steel wire brush or special sandpaper.
Clean bonding surfaces with cleaning agent R1.
Allow cleaned surfaces to dry for approx. 5 minutes.
Bonding surfaces must be completely dry.