65 50 170 Removing and installing/replacing cover for Central Information Display (CID, JC): Notes

WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2015 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: These repair instructions apply to the Central Information Display (CID) of the manufacturer Johnson Controls (JC).

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Necessary preliminary work:

Remove CENTRAL INFORMATION DISPLAY

Release screws (1).

Tightening torque 65 50 2AZ

NOTE: To tighten screws, use special tool 00 9 460 .

Remove rear cover (2) from

Central Information Display (3).

Fig 1: Identifying Screws, Rear Cover And Central Information Display

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Make sure rear cover (2) is correctly seated on Central Information Display (3).

IMPORTANT: Do not damage or scratch the display!

Carefully disconnect the plug connection (1).

Carefully raise latch mechanisms (2) and remove Central Information Display (3) from Central Information Display cover (4).

Installation note:

Make sure latch mechanisms (2) are heard to click into place.

Make sure rear Central Information Display cover (4) is correctly seated on Central Information Display (3).

Ensure correct cable routing in guide (5).

Fig 2: Identifying Plug Connection, Latch Mechanisms, Central Information Display Cover And Guide

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Before/after assembly, cover is bolted to the Central Information Display, correct installation position must first be checked!

Installation note:

Before connecting the screw connection, check whether latch mechanisms marked with an arrow are correctly seated.

Fig 3: Identifying Central Information Display Installation Position

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Before connecting the screw connection, check all-round rim at the places marked with an arrow.

Fig 4: Identifying Screw Connection Installation Position

Courtesy of BMW OF NORTH AMERICA, INC.