37 10 001 Initial operation with test run of Dynamic Drive: Notes
WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2015 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The Service function Initial operation of Dynamic Drive must be carried out after:
- Work on the Dynamic Drive system which involved opening hydraulic lines
- Replacement/Programming/Coding Dynamic Drive control unit (ICM - V - High)
IMPORTANT:
Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Using contaminated equipment to add fluid may introduce dirt particles into the fluid reservoir and significantly reduce the service life of the ARS and power steering system. Do not use any filler funnels or similar!
Use only Pentosin CHF11S from original containers!
The fill level may only be checked or adjusted when the engine is stopped! Adjust fill level if possible in middle between 20° and 80°C.
Ensure that the cap is fully screwed in prior to the fill level check.
NOTE:
To avoid mix-ups when filling with hydraulic fluid, mark the fluid reservoirs or their caps with identification marks.
CHF Pentosin CHF11S