52 14 392 Removing and installing/replacing front left or right crash-active head restraint (model year 2009 through production date 07/2012)
WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2015 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Comply with SAFETY REGULATIONS
for handling components with gas generators.
Incorrect handling may result in triggering of the crash-active headrest and thereby cause injury.
Incorrect handling may result in triggering of the crash-active headrest and thereby cause injury.
Switch off the ignition!
Necessary preliminary work:
- Disconnect BATTERY NEGATIVE CABLE
- Normal/electric seat: Remove REAR PANEL .
- Comfort seat: Remove upper REAR PANEL .
NOTE:
Removal with manual and electrical height adjustment is described below.
Starting situation:
Head restraint is in the crash position after activation.
A triggered head restraint can be recognized by the padded section which has moved upwards.
Unlock PLUG CONNECTION (1) and disconnect.
Feed out wiring harness from head restraint height adjustment and foam material.
Lever out retaining clips (1)
On vehicles from version 04/2010:
Loosen the retaining screw (1) from the head restraint (2).
Tightening torque 52 10 6AZ .
Lift out head restraint.
IMPORTANT:
During head restraint removal the guide sleeves are involuntary disengaged.
The bent linkage of the head restraint causes the guide sleeves also to be pulled out in some cases.
Prior to installation of the head restraint, make sure you check the guide sleeves for whether all retaining lugs are correctly locked.
The bent linkage of the head restraint causes the guide sleeves also to be pulled out in some cases.
Prior to installation of the head restraint, make sure you check the guide sleeves for whether all retaining lugs are correctly locked.