67 11 555 Removing and installing/replacing actuator drive for fuel filler flap: Replacement

WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2015 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.

Unhook emergency operation tensioning strap (2) from clamp (1) and remove from locking pin (3) of actuator drive (4).

Fig 1: Identifying Emergency Operation Tensioning Strap, Clamp, Locking Pin And Actuator Drive

Courtesy of BMW OF NORTH AMERICA, INC.

Turn sleeve (1) with a suitable tool (e.g. pointed pliers) approx. 45° in direction of arrow and pull out of receptacle (2).

Fig 2: Pulling Out Receptacle

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Make sure sleeve (1) is correctly seated on locking pin for fuel filler flap (2).

Fig 3: Identifying Sleeve And Fuel Filler Flap

Courtesy of BMW OF NORTH AMERICA, INC.