31 35 000 Removing and installing/replacing front stabilizer

WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2015 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary work:

Remove FRONT UNDERBODY PROTECTION .
Remove BOTH ANTI-ROLL BAR LINKS FROM ANTI-ROLL BAR .

Release screws (1).

Tightening torque 31 35 1AZ

Remove anti-roll bar (2) downwards.

Fig 1: Identifying Anti-Roll Bar Link With Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Replace screws.

Pay attention to installation location of retaining bracket and mounting plate!

Nose (1) on retaining bracket must point left in direction of travel (F)
Curve (2) on lower mounting plate points to rubber bearing

Fig 2: Identifying Nose On Retaining Bracket And Curve On Lower Mounting Plate

Courtesy of BMW OF NORTH AMERICA, INC.