4.2 Components with pre-fitted adhesive tape

WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2015 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.

Pull off liner* from adhesive side (if adhesive area is large, do not pull off liner completely)
Align component in correct position on vehicle
Press down component over entire adhesive area
Minimum contact pressure = 15 N/cm (firm thumb pressure reaches approx. 35 N/cm.)

* Liner is the protective film on the adhesive tape