51 71 447 Removing and installing or replacing panel for cover on left or right side member

WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2015 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.

Operations on right side analogous to left side shown. Use graphics in a mirror-inverted way.

Necessary preliminary tasks:

Remove UNDERBODY PANELLING .

NOTE: Open doors.

Release screws (1).

Unclip trim panel for cover on side member (1) in direction of arrow and remove.

Installation note:

Make sure cover is correctly seated on side member (1).

Fig 1: Removing Trim Panel From Cover On Side Member

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Protective film at rear door post must be neither missing nor damaged in order to prevent paint abrasion between side frame and trim panel for cover at side member.

(Sourcing reference BMW Parts Department)

Foil strip is slightly bent in area (1) and must not project over edge (2).

Fig 2: Identifying Project Over Edge And Bent Area

Courtesy of BMW OF NORTH AMERICA, INC.