Preparing front spoiler

WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2015 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.

Clean adhesive area on bumper panel using CLEANING AGENT R2 .

Lay out clamp, adhesive tape and rigid foam block (approx. 105 mm high) for fixing in place.

Clean contact surface (2) of front spoiler.

Apply adhesive bead (Ø = 5 mm) according to dimension (A) to the contact surface (2) of the front spoiler.

Fig 1: Identifying Adhesive Bead Applying Area On Front Spoiler

Courtesy of BMW OF NORTH AMERICA, INC.

= 15 mm from edge of spoiler