Removing the hub cap

WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2015 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.

Press on emblem in area (1) and turn in direction of arrow.

Fig 1: Turning Hub Cap By Pressing On Emblem

Courtesy of BMW OF NORTH AMERICA, INC.

Open lock with key (1) and remove hub cap (2).

Fig 2: Identifying Lock Key And Hub Cap

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Make sure that there are 10 friction film pieces (see arrows) on the hub cap.

When replacing the hub caps, the supplied friction film pieces must also be attached.

Fig 3: Locating Friction Film Faces On Hub Cap

Courtesy of BMW OF NORTH AMERICA, INC.

Note on valve insert:

IMPORTANT: In the event of repair, only valve insert (1) may be replaced!
The screw valve (2) must not be removed from the wheel rim!

Fig 4: Identifying Valve Insert And Screw Valve

Courtesy of BMW OF NORTH AMERICA, INC.