64 11 540 Replacing distributor housing at top for heating and air-conditioning unit

WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2015 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary work:

Remove INSTRUMENT PANEL TRIM

Release screws (1). Installation note: Replace screws.

Remove cable routing holder (2) from the working area.

Fig 1: Identifying Cable Routing Holder And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Heating and air-conditioning unit removed for purposes of clarity.

Unclip deflection arm (1) from angle positioning lever (2).

Installation note:

Deflection arm (1) must snap audibly into place!

Fig 2: Identifying Deflection Arm And Angle Positioning Lever

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Unlock and disconnect plug connections on upper distributor housing (2).

Remove upper distributor housing (2).

Installation note:

Make sure filter housing guide lugs (3) are correctly seated in associated guide tabs on upper distributor housing (2).

Fig 3: Identifying Upper Distributor Housing, Guide Lugs And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Servomotors must be re-addressed in the event of replacement!

Addressing can only be carried out with the BMW diagnosis system.

Service functions:

Body
Heating and air conditioning function
Flap motors
Re-address flap motors