64 51 530 Removing and installing/replacing expansion valve for rear air conditioner (F02 only)
WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2015 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove REAR AIR CONDITIONER
Release screws (1) on flange holder (2).
Installation note:
Make sure flange holder (2) is correctly seated in associated guide on rear air conditioner housing.
Pull condensation water drain hose (1) out of gaiter (4).
Unscrew nuts (2).
Remove flange (3) incl. holder and gaiter (4).
Installation note:
Valve openings must be fully exposed and must not be covered either by flange (3) or the flange holder.
Release screws (1) and carefully remove expansion valve (2).
Tightening torque 64 53 6AZ .
Installation note:
Replace sealing rings.
Use special tool 00 9 030 to mount sealing rings without damaging them.