24 34 020 Replacing sealing sleeve for transmission housing (GA6HP26Z) (N63)

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2014 BMW Alpina B7L, 2014 BMW Alpina B7, and 2013 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

24 2 390

IMPORTANT:

After completion of work, check TRANSMISSION OIL LEVEL .

Use only approved TRANSMISSION OIL .

Failure to comply with this instruction will result in serious damage to the transmission.

Necessary preliminary tasks:

IMPORTANT: Support transmission with workshop hoist.

Unlock and disconnect plug (1) by turning.

Fig 1: Turning Plug

G06889516

Courtesy of BMW OF NORTH AMERICA, INC.

Insert special tool 24 2 390 in sealing sleeve (1).

Fig 2: Inserting Sealing Sleeve Using Special Tool 24 2 390

G06889517

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock sealing sleeve with slide (1).

Fig 3: Unlocking Sealing Sleeve With Slide

G06889518

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Note position of sealing sleeve.

Pull out sealing sleeve (1).

Installation note:

Screw in sealing sleeve partially (lug in upper area). Turn until lug engages in groove of transmission. Slide in sealing sleeve.

Lug on sealing sleeve must not be damaged!

Fig 4: Pulling Out Sealing Sleeve

G06889519

Courtesy of BMW OF NORTH AMERICA, INC.