24 00 054 Installing exchange transmission (GA8HP45Z) (N55)
WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2014 BMW Alpina B7L, 2014 BMW Alpina B7, and 2013 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
- Do not let skin come in contact with transmission oil and do not inhale transmission oil vapors.
- Wear protective gloves.
- Ensure adequate ventilation
Drain automatic transmission oil at oil drain plug.
Tightening torque 24 11 2AZ .
IMPORTANT:
After completion of repair work, program control transmission control unit.
Recycling:
Catch and dispose of escaping transmission oil.
Observe country-specific waste disposal regulations.
IMPORTANT:
- Before installing exchange transmission, always flush TRANSMISSION OIL COOLER TOGETHER WITH LINES .
- After completion of repair work, CHECK TRANSMISSION OIL LEVEL
- Use only approved TRANSMISSION OIL
.
Failure to comply with this requirement will result in serious damage to the automatic transmission
Exchange transmissions come filled with oil
Necessary preliminary tasks:
- Remove AUTOMATIC TRANSMISSION .
- Modify transmission mounting bracket
Modify transportation retainers.
Convert all cable clips.
Convert all seal plugs.
Convert protective cap on output shaft.
IMPORTANT:
After removing transportation retainer, secure torque converter against slipping out.
Transmission identification:
- On type plate