00 11 237 Checking/topping up oil level in automatic transmission (GA6HP19Z) (N54)
WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2014 BMW Alpina B7L, 2014 BMW Alpina B7, and 2013 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Use only the approved TRANSMISSION OIL .
Failure to comply with this requirement will result in serious damage to the automatic transmission.
Installation note:
Tighten down filler plug using:
- Hexagon wrench 8 A/F
- Torque wrench
- Socket 8 A/F
Topping up transmission oil after a repair:
Stand vehicle on a level surface and secure against rolling off.
Undo filler plug (1).
Installation:
Replace sealing ring.
Top up transmission oil until it emerges from filling orifice.
Start engine.
Replenish transmission oil until it emerges from filling orifice.
Screw in filler plug (1).
Tightening torque: 24 11 3AZ .
Press brake pedal to floor and shift through gears 1 to 6 several times at idle speed. Then shift to "P" position (Park).
Then check oil level.
Checking oil level:
- Connect BMW Diagnosis and Information System.
- Call up Service functions (drive).
- Carry out oil level check in accordance with instructions.