LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2010 >> Cooper S, 2D Hatchback, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2542 (Engine Electrical System - Repair (N63)) >> 1200 Troubleshooting >> 61 00... Notes on handling wiring harnesses and cables >> The following additionally applies

The following additionally applies

WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2014 BMW Alpina B7L. However, it is still accessible from the selected car via links, so may be relevant.

Shielded lines 

Contact points in the shield can cause problems with regard to noise radiation and interference immunity. Consequently, distinctions have to be drawn between the following types:

Coaxial line 

CVBS lines 

HSD lines 

Optical fibre cable  :

NOTE: Optical fibre cables are colored differently as follows:
  • Green = MOST  ( edia riented ystems ransport) optical fibre
  • Yellow = ISIS  ( ntelligent afety ntegration ystem) optical fibre
  • Orange = repair optical fibre cables
IMPORTANT:
  • Optical fibre cables are permitted to show only one separation point (bridge), replace optical fibre cables if necessary
  • Smallest permissible bending radius is 25 mm
  • Avoid influence of heat = 85°

Treating cables and optical fibre cables

FlexRay: 

It is possible to repair the FlexRay. In the event of damage, the cables can be joined with conventional butt connectors.

NOTE:
  • The line is a twisted cable. If possible, maintain twist in line after repair.

Airbag lines: 

Repairing airbag cables

Ribbon cables: 

Repairing ribbon cables Z



Shielded lines (coaxial lines): 

IMPORTANT: Shielded lines may not be repaired!

Fibre-optic cable: 

NOTE: Fibre-optic cables are colored differently as follows:
  • Green = MOST  ( edia riented ystems ransport) optical fibre
  • Yellow = ISIS  ( ntelligent afety ntegration ystem) optical fibre
  • Orange=repair fibre-optic cables
IMPORTANT:
  • Optical fibres may only reveal one separation point (bridge); renew optical fibre if necessary
  • Smallest permissible bending radius is 25 mm
  • Avoid effects of heat = 85°

Treating cables and fibre-optic cables:  See TREATING CABLES AND FIBRE-OPTIC CABLES .