12 00... Notes/information on start assistance (jump starting): Operation

WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2014 BMW Alpina B7L. However, it is still accessible from the selected car via links, so may be relevant.

It is essential to conform to the procedures so as to avoid injury to persons or damage to parts.

Automatic transmission: select drive position "P", apply parking brake.
Manual transmission: move gear lever to neutral position, apply parking brake.
Ensure that the jump leads cannot get caught in rotating parts, e.g. fan.
First connect both positive poles of the batteries with one jump starting cable (red).
Use the battery positive terminal in the engine compartment for vehicles with the battery in the luggage compartment.
Then use the second jump starting cable (black) to connect the negative post of the current-supplying battery with the earth/ground point (not the negative pole or the body) of the vehicle to be started.
IMPORTANT: Do not connect the second jump starting cable (black) with the negative pole of the battery in the vehicle to be started. Produced gas could be ignited by sparks.

Risk of explosion!

After the engine of the vehicle to be started has fired, first disconnect the jump starting cable between the negative pole and the earth/ground point. Then remove the starting cable from the positive poles.