34 00 027 Replacing fluid in brake system

WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2015 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Read and comply with GENERAL INFORMATION .

Necessary preliminary work:

Remove left sensor opening

IMPORTANT:

When carrying out repairs to the brake system, follow the procedure set out in BLEEDING BRAKE SYSTEM WITH DSC .

Use only BMW-approved BRAKE FLUIDS .

Connect bleeder unit to expansion tank and switch on.

NOTE:

Follow the applicable equipment manufacturer's Owner's Handbook.

Charging pressure should not exceed 2 bar.

Fig 1: Connecting Bleeder Unit To Expansion Tank

Courtesy of BMW OF NORTH AMERICA, INC.

Completely bleed the brake system:

Connect bleeder hose with collecting tray to bleeder valve on rear right brake caliper.

Open bleeder valve and purge until clear, bubble-free brake fluid emerges.

Close bleeder valve.

Follow same procedure on rear left, front right and front left wheel brake.

IMPORTANT:

In vehicles with 6-piston fixed caliper brakes:

Two bleeder valves per brake caliper are installed on the front axle.

In each case start by bleeding at the outer bleeder valve and then bleed at the inner bleeder valve.

Fig 2: Identifying Bleeder Valve

Courtesy of BMW OF NORTH AMERICA, INC.

Switch off bleeder unit and remove from expansion tank.

Check brake fluid level. If necessary, top up/draw off to "Maximum" level.

Close expansion tank.

NOTE: Pay attention to seal (1) in sealing cap.

Fig 3: Identifying Sealing Cap Rubber Seal

Courtesy of BMW OF NORTH AMERICA, INC.