61 61 270 Removing and installing or replacing console for windscreen washer system complete with motor

WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2015 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

IMPORTANT: Before installing the wiper arms, allow wiper motor to run into rest position.

IMPORTANT: Emergency operation - danger of injury!

Disconnect BATTERY CABLE

Necessary preliminary work:

Remove COWL PANEL COVER
Remove LEFT/REAR SUSPENSION CROSS-BRACE

Release screws (1).

Tightening torque 61 61 1AZ .

Remove console for windscreen wiper system (2) in direction of arrow and disconnect plug connection (3).

Fig 1: Removing Console For Windscreen Wiper System

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Vacuum line (1) must not be trapped by windscreen washer system (2).

Contact with vacuum line (1) is only permitted at the positions (A/D/C) specifically designed for this purpose.

Fig 2: Identifying Windscreen Washer System With Vacuum Line

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: As of 09/2009, an additional holder (1) is installed for the vacuum line (2).

Installation note:

Make sure the vacuum line (2) is correctly seated in the holder (1)!

Fig 3: Identifying Windscreen Washer System Vacuum Line With Holder

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: After installing, check freedom of movement between wiper kinematics and vacuum line!