61 31... Remount operating unit of the additional seat function (screwed version)

WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2015 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove OPERATING UNIT OF ADDITIONAL SEAT FUNCTION

Removal:

Release all screws by means of screwdriver (1) on the operating unit (2).

Fig 1: Removing Operating Unit Screws Using Screwdriver

G10064155

Courtesy of BMW OF NORTH AMERICA, INC.

Remove the rear panel (1) and feed out the printed circuit board (2).

Fig 2: Identifying Printed Circuit Board And Rear Panel

G10064156

Courtesy of BMW OF NORTH AMERICA, INC.

Take out the pressure pin (1) from the operating unit (2).

Fig 3: Identifying Pressure Pin And Operating Unit

G10064157

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip button (2) with the help of screwdriver (1) and remove.

Fig 4: Removing Button Using Screwdriver

G10064158

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Add the button (1) to the operating unit (2) and lock using pressure.

Fig 5: Installing Button

G10064159

Courtesy of BMW OF NORTH AMERICA, INC.

Add pressure pin (1) to the operating unit (2).

Fig 6: Connecting Pressure Pin To Operating Unit

G10064160

Courtesy of BMW OF NORTH AMERICA, INC.

Add the printed circuit board (2) and then the rear panel (2) to the operating unit.

Fig 7: Identifying Printed Circuit Board And Rear Panel

G10064161

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten all screws on the operating unit (2) with the help of screwdriver (1).

IMPORTANT: Pay attention to the freedom of movement and function of the remounted button.

Fig 8: Removing Operating Unit Screws Using Screwdriver

G10064162

Courtesy of BMW OF NORTH AMERICA, INC.