61 31 342 Removing and installing/renewing gear selector switch: Installation
WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2015 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.
Installation note:
Align gear selector switch (2) centrally.
Connect corresponding connector.
Join gear selector switch (2) to center console (3).
Tighten all screws (1).
Tightening torque 61 31 1AZ.
Replacement:
NOTE:
A new connector with deviating pin assignment will be installed in the following vehicles.
- F25 from 03/2011
- F01, F02, F03, F04, F07 from 09/2011
- F10, F11, F12, F13, F18 from 03/2012
On the above-mentioned vehicles which were produced before the relevant data the wiring harness must if necessary be reconnected from the previous 8-pin connector to a new 10-pin connector (BMW part number 9 132 577) with special tool 61 0 313 (release tool).
PIN ASSIGNMENT
| Eight-pin connector: current pin | Ten-pin connector: new pin |
|---|---|
| 1 | 10 |
| 2 | 7 |
| 3 | 3 |
| 4 | 4 |
| 5 | 8 |
| 6 | 5 |
| 7 | 6 |
Replacement:
Carry out VEHICLE PROGRAMMING/ENCODING .