LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2010 >> Cooper S, 2D Hatchback, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2539 (General Electrical System - Repair - F01/F02) >> Plug Connection, Terminal, Fuse Box >> 61 00... Notes on handling wiring harnesses and cables >> The following additionally applies

The following additionally applies

WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2015 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.

Shielded lines (coaxial lines): 

IMPORTANT: Shielded lines may not be repaired!
  • This may lead to indifferences in noise radiation and interference immunity at contact points in the shield
  • To satisfy the requirements of the type approval, it is essential to replace shielded cables completely

Fibre-optic cable: 

NOTE: Fibre-optic cables are colored differently as follows:
IMPORTANT:
  • Optical fibres may only reveal one  separation point (bridge); renew optical fibre if necessary
  • Smallest permissible bending radius is 25 mm
  • Avoid effects of heat ≥ 85 °

Treating cables and fibre-optic cables: see TREATING CABLES AND FIBRE-OPTIC CABLES .

FlexRay: 

It is possible to repair the FlexRay. In the event of damage, the cables can be joined with conventional BUTT CONNECTORS AND HEAT-SHRINK HOSES  .

NOTE:
  • FlexRay lines may only reveal one  separation point (bride); renew complete line if necessary
  • The cable is a twisted cable. If possible, maintain twisted cable after repair

Airbag lines: 

REPAIRING AIRBAG CABLES 



Shielded lines 

Contact points in the shield can cause problems with regard to noise radiation and interference immunity. Consequently, distinctions have to be drawn between the following types:

Coaxial line 

CVBS lines 

HSD lines 

Optical fibre cable: 

NOTE: Optical fibre cables are colored differently as follows:
IMPORTANT:
  • Optical fibre cables are permitted to show only one separation point (bridge), replace optical fibre cables if necessary
  • Smallest permissible bending radius is 25 mm
  • Avoid influence of heat ≥ 85 °

Treating cables and optical fibre cables

FlexRay: 

It is possible to repair the FlexRay. In the event of damage, the cables can be joined with conventional butt connectors.

NOTE:
  • The line is a twisted cable. If possible, maintain twist in line after repair.

Airbag lines: 

Repairing airbag cables

Ribbon cables: 

Repairing ribbon cables Z