33 55 021 Replacing both rubber mounts for stabilizer mounting

WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2015 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove STABILIZER FROM REAR AXLE CARRIER

IMPORTANT: Circo Light must not be used between stabilizer and rubber mount!

Remove retaining bracket (1) and rubber mount (2) from stabilizer.

Installation note:

Coat rubber mount with Circo Light to install retaining bracket.

Fig 1: Identifying Retaining Bracket And Rubber Mount

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Keep stabilizer clean and free of oil and grease.

Mount rubber mount (1) by way of slot (2) as pictured on stabilizer.

Fig 2: Identifying Rubber Mount And Slot

Courtesy of BMW OF NORTH AMERICA, INC.