33 11 271 Replacing cover gasket on rear differential (205AL/225AL) at rear
WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2015 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
DANGER OF POISONING if oil is ingested/absorbed through the skin!
RISK OF INJURY if oil comes into contact with eyes and skin!
IMPORTANT:
In event of oil loss, always check rear differential for traces of wear and damage.
To avoid leaks from the rear differential cover, do not use a paper gasket in cars with liquid sealing compounds!
To prevent the differential oil from foaming over, make sure that no traces of the liquid gasket are pressed into the housing.
Necessary preliminary tasks:
- Catch or draw off final drive oil.
- Remove REAR AXLE FINAL DRIVE .
NOTE:
Read and comply with REAR DIFFERENTIAL: ASSIGNMENT TO MODEL SERIES .
IMPORTANT:
To avoid leaks from the rear axle final drive lid, do not use a paper gasket in vehicles with liquid sealing compounds!
To prevent the final drive oil from foaming over, make sure that no remnants of the liquid sealing compound are pressed into the rear axle final drive housing.
To prevent the final drive oil from foaming over, make sure that no remnants of the liquid sealing compound are pressed into the rear axle final drive housing.
Release screws (1).
Tightening torque 33 11 1AZ .
Remove cover.
Installation note:
If necessary, remove remnants of liquid sealing compound with scraper.
Clean sealing surface on lid and rear axle final drive.
Use Loctite 5970 liquid seal.
After installation:
- Add FINAL DRIVE OIL .