26 11 Propeller Shaft. complete
WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2015 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.
TIGHTENING TORQUE SPECIFICATION - PROPELLER SHAFT
| Type | Thread | Tightening specifications | Dimension | ||
|---|---|---|---|---|---|
| 1AZ | Front flexible disc to transmission output flange ZNS screws and nuts All versions |
Replace bolts and nuts Jointing torque and angle of rotation must be observed without fail Tightening via screw |
|||
| F01/F02/F03/F07/F10/F11/F12/F13/F18/F25 | M12-10.9 | Jointing torque | 55 Nm | ||
| Angle of rotation | 90 ° | ||||
| 2AZ | Front flexible disc to propeller shaft ZNS screws and nuts All versions | Replace bolts and nuts Jointing torque and angle of rotation must be observed without fail Tighten via nut |
|||
| F01/F02/F03/F07/F10/F11/F12/F13/F18/F25 | M12-10.9 | Jointing torque | 55 Nm | ||
| Angle of rotation | 90 ° | ||||
| 3AZ | Flexible disc, rear, to transmission drive flange (inserted) ZNS screws and nuts All versions |
Replace bolts and nuts Jointing torque and angle of rotation must be observed without fail Tightening via screw |
|||
| F01/F02/F03/F07/F10/F11/F12/F13/F18 | ASA M12-10.9 | Jointing torque | 55 Nm | ||
| Angle of rotation | 90 ° | ||||
| 4AZ | Flexible disc, rear, to propeller shaft ZNS screws and nuts All versions |
Replace bolts and nuts Jointing torque and angle of rotation must be observed without fail Tighten via nut |
|||
| F01/F02/F03/F07/F10/F11/F12/F13/F18 | M12-10.9 | Jointing torque | 55 Nm | ||
| Angle of rotation | 90 ° | ||||
| 5AZ | Centre mount to body | F01/F02/F03/F07/F10/F11/F12/F13/F18/F25 | 21 Nm | ||
| 6AZ | Drive flange, rear axle final drive (insert nut to propeller shaft/three-hole flange) | F01/F02/F03/F07/F10/F11/F12/F13/F18 | Replace insert nut! Allow min. 2 hours hardening time | ||
| Jointing torque Loosen the insert nut through 90° |
120 Nm | ||||
| Tightening torque | 85 Nm | ||||
| 7AZ | Front propeller shaft to transfer box/front axle differential | F01/F02/F07/F10/F25 | Replace screws Jointing torque and angle of rotation must be observed without fail | ||
| Jointing torque | 20 Nm | ||||
| Angle of rotation | 45 ° | ||||