11 11 Engine block
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2014 BMW Alpina B7L, 2014 BMW Alpina B7, and 2013 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.
TIGHTENING TORQUE SPECIFICATION - ENGINE BLOCK
| Type | Thread | Tightening specification | Measure | ||
|---|---|---|---|---|---|
| 1AZ | Bearing cap to crankcase (ASA collar screw) | N63 | M11x102 | Replace screws | |
| Jointing torque | 20 Nm | ||||
| Torque angle | 100 ° | ||||
| 2AZ | Bearing cap to crankcase (ASA collar screw 10.9) | N63 | M8x70 | Replace screws | |
| Jointing torque | 10 Nm | ||||
| Torque angle | 55 ° | ||||
| 3AZ | Threaded support sleeves | N63 | Jointing torque | 6 Nm | |
| 4AZ | Angled screw connection to crankcase | N63 | M8x37 | Flanged head screw 10.9 | 34 Nm |
| 5AZ | Spacer bolt, oil pump | N63 | M8 | 34 Nm | |
| 6AZ | Screw plug, water drain | N63 | M14x1.5 | Replace seal | 25 Nm |
| 7AZ | Screw plug, main oil gallery rear and in V - space right | N63 | M18x1.5 | Replace seal | 25 Nm |
| 8AZ | Oil nozzle to crankcase | N63 | M12x1 | 10 Nm | |
| 9AZ | Special tool to crankcase | N63 | M8x35 | 20 Nm | |
| 10AZ | Special tool to crankcase | N63 | M10x35 | 40 Nm | |
| 10AZ | Special tool 11 8 930 to special tool 00 2 300 | N63 | M14x35 | 160 Nm | |