65 50 160 Removing and installing/replacing trim for rear cabin monitor display at front and rear

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 340 , see 00 9 340 DISASSEMBLY AID (2 PIECES) .

IMPORTANT: Trims may only be replaced in pairs so as to avoid differences in color.

Unclip trims (1) on both sides with special tool 00 9 340.

Installation:

Make sure trims (1) are securely seated in rear cabin monitor trim at front.

Fig 1: Identifying Rear Cabin Monitor Trim

G04792745

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Tightening torque 65 52 2AZ , see 65 52 CD/DVD DRIVES AND SPECIAL DEVICES .

Fig 2: Identifying Rear Cabin Monitor Screws Location

G04792746

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip trim for display at rear (1) with special tool 00 9 340 and remove.

Fig 3: Identifying Trim For Display (Rear)

G04792747

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Carefully remove trim for display at front (2) and disconnect plug connection (3).

Installation:

Make sure ribbon cable is securely seated.

Fig 4: Identifying Trim For Display (Front)

G04792748

Courtesy of BMW OF NORTH AMERICA, INC.