65 50 150 Removing and installing/replacing trim for rear cabin monitor base at front and rear

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 340 , see 00 9 340 DISASSEMBLY AID (2 PIECES) .

IMPORTANT: Trims may only be replaced in pairs so as to avoid differences in color.

Using special tool 00 9 340 , unclip trim (1) on both sides.

Fig 1: Identifying Rear Cabin Monitor Base And Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip trim (1) for base at front with special tool 00 9 340 and remove.

Fig 2: Identifying Rear Cabin Monitor Base Trim Location

Courtesy of BMW OF NORTH AMERICA, INC.

Open armrest (1).

Unclip trim (2) for base at rear with special tool 00 9 340 and feed out.

Fig 3: Identifying Armrest And Trim Location

Courtesy of BMW OF NORTH AMERICA, INC.