65 50 057 Removing and installing replacing central information display (CID)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection) , see 61 35... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE) .

Necessary preliminary tasks:

Remove center fresh air grill , see 64 22 164 REMOVING AND INSTALLING OR REPLACING MIDDLE FRESH-AIR GRILLE .

Release screws (1) and feed out CID (2) towards bottom.

Tightening torque 65 50 1AZ , see 65 50 CENTRAL INFORMATION DISPLAY (CID) .

Fig 1: Identifying CID And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connections (1) and unclip cable from holders (2).

Remove CID (3).

Installation:

Holders (2) must not be damaged!

Make sure cable is correctly routed through holders (2).

Fig 2: Identifying Holder, CID And Screws

Courtesy of BMW OF NORTH AMERICA, INC.