36 10 713 Checking one road wheel on balancing machine for face and radial runout (wheel removed)
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
See WHEEL AND TIRES - SPECIAL TOOLS
- 36 1 030
- 36 1 031
- 36 1 032
- 36 1 033
- 36 1 034
- 36 1 035
- 36 1 036
Necessary preliminary tasks:
- Remove WHEEL .
Mount wheel in balancing machine.
To avoid retooling errors, fit the wheel on the balancing machine in the same way as it is also fitted on the car (valve position facing down).
Use suitable wheel centering element supplied with corresponding balancing machine.
- Basic flange
- Wheel centering element
- Type flange
- Clamping nut
Also refer to section on WORKSHOP EQUIPMENT .
Use special tool 36 1 030 for testing.
Special tool 36 1 030 consists of:
- Stand 36 1 031
- Post with clamp 36 1 032
- Holder with clamp 36 1 033
- Clamp 36 1 034
- Measuring roller 36 1 035
- Dial gauge 36 1 036
Position special tool 36 1 030 on tire tread.
Turn wheel by hand and measure max. RADIAL TIRE RUNOUT .
NOTE:
Measuring device must be vertical to tire tread.
Position special tool 36 1 030 on tire side wall.
Turn wheel by hand and measure max. LATERAL TIRE RUNOUT .
NOTE:
Measuring device must be vertical to tire side wall.
Never measure on printed text on tire!
If necessary, CHECK DISK WHEEL (RIM) FOR RADIAL AND FACE RUNOUT .
Never measure on printed text on tire!
If necessary, CHECK DISK WHEEL (RIM) FOR RADIAL AND FACE RUNOUT .