34 41 220 Removing and installing/replacing all handbrake shoes

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

34 4 000

See BRAKES - SPECIAL TOOLS .

Installation:

Remove rear brake disc
Release electromechanical parking brake (EMF)

After completing tasks, adjust parking brake .

Disconnect return springs (1) with brake spring pliers.

Installation:

Return springs (1) must not be overelongated.

Check return springs (1) and replace if necessary.

Return springs (1) must not be mixed up.

Pay attention to installation position of adjustment screw (2).

Apply a thin coat of grease to bush and screw threads,

Refer to Operating Fluids. See BRAKES - OPERATING FLUIDS .

NOTE: Illustration does not show wheel hub.

Fig 1: Identifying Return Springs And Adjustment Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Turn clamping pins (1) with special tool 34 4 000 through 90° and disconnect.

Remove brake shoes (2).

Fig 2: Identifying Clamping Pins And Brake Shoes

Courtesy of BMW OF NORTH AMERICA, INC.